Ford Diesel Particulate Filter (DPF) Static Regeneration Guide

Here is an easy guide on Ford Diesel Particulate Filter (short call DPF) Regeneration. Below detail the step-by-step procedures. Please check and hope you can get useful information from this article.

What device you need to do DPF Generation?

Here we take X431 Pro as an example, you can choose other devices.

Ford DPF Generation detail procedures:

Connect X431 Pro Bluetooth DBSCar Connector

Plug the Bluetooth DBSCar connector into your car via the OBD2 socket

Open the X431 Software

• On the device, navigate to the software interface.
• Select:
  • “American”
  • “Ford”

Select the Correct Software Version

Choose “Ford series software V46.20.”

Automatic Vehicle Search

• Select “Automatically Search” to detect the vehicle.

• Verify the vehicle specification and click “OK.”

Select Fuel Type

• Choose “Fuel Type = Diesel.”
  • hình ảnh: Select “Fuel Type=Diesel”

Access the System Selection

• Navigate to “System Selection.”

• Select “PCM (Powertrain Control Module)” and click “OK.”

Access Special Functions

• Select:
  • “Special Function”
  • “PCM Service Function”
  • Click “OK.”

Start the Regeneration Process

• Choose “Diesel Particulate Filter Static Regeneration.”

Follow System Prompts

• Turn the ignition to the ON position.
• Wait for the system to read fault codes.

 

Turn Ignition OFF

• Pay attention to the prompts and click “Yes.”

Regeneration Process Duration

• The test will take approximately 2500 seconds (about 42 minutes).
• Confirm by selecting “Yes.”
• Wait until the process is complete.

Complete the Procedure

• Once done, click “OK.”
• Turn the ignition to the OFF position.

Procedure Completion

The DPF static regeneration process has been successfully performed. Done!